• Dynatrace Portal
  • interactive Charts
  • Charting


My test is configured to run every 15 minutes on 6 nodes, but the Interactive Chart shows data points every 5 minutes. How can this happen?


The test is not run on all 6 nodes at the same time, so there may be a test run at a 5-minute point within the 15-minute test interval. 

The raw scatter chart shows the actual time for each test run. When the data is aggregated for the main Interactive Chart, the individual data points will be aggregated for the selected time interval.

To chart the data to match the interval for the test runs, select the appropriate value from the Interval list above the chart.

For more information about configuring charts, see the help page Interactive Charts.