Enter Case number reference for associated cases.

Case #

Status:

Type: APM as a Service

Old Article ID: 4950

Old Article Type: problem

 

Information:

Dynatrace Portal > Monitor & Analyze > Diagnostic Utilities > Instant Test: Last Mile

I created a custom peer population, and then created a test using it. When I run an instant test from the peer population to make sure my test can run fine, the test displays pending for more than 20 minutes. Whereas, when I run the instant test from a peer that I know is included in the peer population, it returns result in a couple of minutes.

Then about an hour later, I run the instant test from the peer population again. It runs right away.

That behavior is normal.

When a peer population is newly created, it may take a while for our system to set up the population in the back end. On average, it may take an hour until it can start to run instant tests.