topic Re: Honeycomb tile clicking is off in Dashboarding

Honeycomb tile clicking is off

Erin_Scot — Wed, 21 Jan 2026 21:49:49 GMT

When looking at a honeycome tile in new dashboards, you are meant to hover over a specific section of the tile, then click the pop-up that appears. Unfortunately, if you don't click precisely in the right spot, when you move your mouse in order to click to get to the details, you end up just moving to a different tile instead. Is there a way to make it clickable directly from the honeycomb, instead of needing to click the pop-up?

I have a video to show better what I mean, but it doesn't appear I can upload that here.

Re: Honeycomb tile clicking is off

raksh_hitha — Thu, 22 Jan 2026 15:27:44 GMT

Hi @Erin_Scot
I hope I understood you correctly. If you click anywhere inside a honeycomb cell, the pop‑up will stay open even when you hover over another cell.

Re: Honeycomb tile clicking is off

Erin_Scot — Thu, 22 Jan 2026 16:59:07 GMT

Unfortunately, that does not seem to be the case in the new dashboards. In Dashboards Classic, I believe that is true. But in the new dashboards, if you don't click perfectly, as soon as you move the mouse to click the pop-up, you end up hovering over other cells instead.

Re: Honeycomb tile clicking is off

raksh_hitha — Thu, 22 Jan 2026 18:23:52 GMT

Hi, I tried checking it again.

When I click inside the cell…

…and then hover over another cell, the pop‑up still stays.

You just have to make sure you tap on it correctly; once it’s on the cell, it should work.