topic Re: Port opening for Active gate in Dynatrace SaaS in Open Q&A

Port opening for Active gate in Dynatrace SaaS

sangeetha_mitta — Tue, 29 Jan 2019 12:34:57 GMT

Could you please clarify on the below? (dummy ip address are mentioned below)

Active gate VM Has 3
IPs.

IP in VLAN -123.11.11.23

IP Patio - 342.144.145.37

Public IP address in DMZ - 222.218.27.88

we have raised
firewall port from source 123.11.11.23(IP IN VLAN) to SAAS tenant with 8443 port.

Is this
correct or do we need to select source IP as 222.218.27.88(public IP in DMZ) instead
172.21.14.73.

Thanks&Regards

Sangeetha

Re: Port opening for Active gate in Dynatrace SaaS

Radoslaw_Szulgo — Fri, 24 Jan 2020 16:37:20 GMT

If you run multiple NICs define the communication NIC by defining that in config.properties file. Set bindToNetworkInterface property under section [connectivity]

Then restart AG.

Re: Port opening for Active gate in Dynatrace SaaS

ChadTurner — Fri, 24 Jan 2020 20:23:51 GMT

Review the following document as what ports need to be open depending on your use case: https://www.dynatrace.com/support/help/setup-and-configuration/dynatrace-activegate/configuration/which-network-ports-does-activegate-use/?_ga=2.37350691.2023751569.1579873345-1052794368.1579873345