cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About addition to dtserver.ini

dt_its3-1
Inactive

Hi,

Since the number of reports was over 100, I will add the following settings to dtserver.ini according to the manual.

-Dcom.dynatrace.diagnostics.reporting.maxTableRows=XXXX

Do I need to restart the DTServer process in order to reflect this setting?

Best Regards,

Takunobu a

3 REPLIES 3

tthat
Inactive

in the manual is it wriiten to restart, if not you can

dt_its3-1
Inactive

Hi Taneshaa-san,

Thank you for your quick responce.

By the way, if you set the key from [Dynatrace server] - [settings] - [general] - [DEBUG Option] using DEBUG mode, will the DT server restart immediately? In my verification environment it was reflected immediately without being restarted. Is it correct my understanding that adding settings from the DEBUG option will be reflected without restarting?

Best Regards,

Takunobu Atsukawa

@Daichi S.

will the DT server restart immediately? No you need to restart the server when we add any parameter in debug mode it get updated immediately just for being more precise we restart the server so that its been applied properly.

Note:- restarting depends from parameter to parameter. meanwhile you can monitor your env if the parameter is working fine without restart then your are in god good condition.