cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Error when adding a new Cluster Node

DynaQ
Participant

Hi,

 

We are getting below error when adding a second cluster node

 

Upgrade failed after 2 seconds.
Exit code: 3

Errors:
IP address <IP-1> used in previous installation doesn't belong to this machine anymore.

 

Just to highlight that <IP-1> is the IP address of the first Cluster node

 

Thanks,

3 REPLIES 3

pahofmann
DynaMight Guru
DynaMight Guru

Probably best to open a support ticket for this.

Dynatrace Certified Master, AppMon Certified Master - Dynatrace Partner - 360Performance.net

Julius_Loman
DynaMight Guru
DynaMight Guru

Aren't you accidentally running the installer on the first node? If not, be sure to check connectivity from the new node to be added to the existing nodes, including the one with the IP address mentioned. 

Certified Dynatrace Master | Alanata a.s., Slovakia, Dynatrace Master Partner

Radoslaw_Szulgo
Dynatrace Guru
Dynatrace Guru

So you either had a problem when uninstalling the previous attempt to install Dynatrace Managed on this host and /etc/dynatrace.conf was left - for example, you might have cloned the machine from the first node. Or you're passing in the installation parameters the IP that's not on the host's interfaces list. 

Senior Product Manager,
Dynatrace Managed expert