cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

This product reached the end of support date on March 31, 2021.

AMD and Netflow

henk_stobbe
DynaMight Pro
DynaMight Pro

Can anybody tell me how to instruct the amd gather Netflow traffic? Can I make that work on a communication port or do I still need to alocate a seperate port. Traffic is send to the main interface,


 


KR Henk Stobbe

9 REPLIES 9

adam_piotrowicz
Dynatrace Pro
Dynatrace Pro

Make sure nfc service on AMD is running by executing ndstat command. If it's stopped start it by executing service nfc start command.

Using communication interface is fine, as it is to be shared with netflow traffic from routers.

Adam,


 


Thx for the quick response, I have noticed I have a temp licence: AMD_VFC \and the AMD shows the yellow marker, no license for Netflow, I suppose I have to contac sales rep?


 


KR Henk Stobbe


 


 


 

If you have this feature in your contract I believe it's enough to create support ticket that will be routed to License Dept. Otherwise looks like Sales Rep. is right person. I'm not sure but I think you can also ask for emergency license ...

I have received new license but it looks like it is not distributed to amd. I can see it in lic man and console. Any suggestions?


 


KR Henk

Check it in DLM, then go to http://CAS/About and see if it's listed there, then go to AMD and execute:

rcmd show licenses

command. Don't check it in RUM Console as licenses info in relays on the info from the AMD.

I filled in the SNMP params, and everything worked like a charm,

 

KR Henk Stobbe

Adam,


 


License is working (forgot to connect CAS to AMD (wink))


Netflow is arriving on the AMD (tcpdump)


Netflow is configured on Console (I do not see correct flow from the cisco's, I see neighbour flow in error ofcourse)


 have 4 physical interfaces on the AMD, two are connected and used as BOND0, (shows up in config script as unused with correct IP)


 



  • eth0 is default comm In+Out traffic

  • eth1 is unused traffic Y

Do I have to change BOND0 from communication to capture mode, or should it already work? Or is it not possible to use this virtual device?


 


KR Henk Stobbe


 


 

Henk,

NFC receives its traffic through a communication interface, so bond0 configured as comm is perfectly fine.

Wojtek.

Woljtek,

 

Thx for your reply, you are right. Everything works,

 

Henk