cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

use Virtual port on AMD ?

jeanphilippe_le
Newcomer

Hi,

Is it possible to use a Virtual port on AMD ? In the RTM configuration table, there is nothing in available driver column for the virtual one. When I save, rtminst try to install a driver but failed.


2 REPLIES 2

What is your OS version, and AMD version?
Are you trying to use the bond as sniffing interface? I do not think that is supported nor needed.
What is your communication port? I think the bond is supposed to be?

See: https://www.dynatrace.com/support/doc/dcrum/instal...

where it states:

Do not configure sniffing interfaces

Sniffing interfaces are administered by the monitoring software.


  • Do NOT do any network configuration for sniffing interfaces.
  • Do NOT use DHCP or assign a static IP address to sniffing interfaces.
  • Make sure no network configuration is set up for sniffing interfaces.

jeanphilippe_le
Newcomer

My OS version is Red Hat Enterprise Linux Server release 7.5 (Maipo)
and Kernel version 3.10.0-862.11.6.el7.x86_64

AMD version 17.0.5.50


It's right, Bond0 is my communication port.
The others ports (eno* and ensl*) will be used for sniffing