cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Any reference Document in Dynatrace will provide details about enabling “read access for all OIDs to our user” for SNMP device

Abidyaseen
Advisor

Hi

Do we have any reference Document or steps that will explain to us how can we provide   “read only access on all OIDs to a user” for the SNMP device 

2 REPLIES 2

p_devulapalli
Champion

@Abidyaseen - If I understood your question correctly, you might need to set a read-only community string on the device to read the OID's via SNMP

Here are the steps for a Cisco device as an example

https://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/7282-12.html#t...

It will be bit different if you are using SNMPv3

https://community.cisco.com/t5/networking-knowledge-base/configuration-template-for-snmpv3/ta-p/4666...

Hope this helps

 

 

 

Phani Devulapalli

Yeah, SNMP is just a protocol to make the data available. How to configure authentication etc... will depend on the particular technology/device.

Featured Posts