I have noticed that in some situations services with similar names appear, where there should clearly be only one. The following is an example:
The blocks in green and orange have exactly the same names in all cases I have observed. The only difference is that the one that has real traffic are always the ones that have the port numbers, like in this case “:80,443”
The other ones only have occasional traffic, and all the ones I’ve seen have in common Purepaths with errors, like the ones below:
- Some data could not be collected or transmitted. This is most likely due to a resource congestion on network, host or process level in your monitored environment (Diagnostic codes: C1, C2, A5)
- Some data could not be collected or transmitted. This is most likely due to a resource congestion on network, host or process level in your monitored environment (Diagnostic code: C2)
Now, this introduces some confusion when looking at the list of services. So, two questions:
- Can someone confirm that this is a procedure of the Dynatrace platform, when it has to put Purepaths which it doesn’t know where to put them?
- Is it possible to deal with these Purepaths in some other way, through Settings?
