Toggle auto-refreshing on and off faster

This tip comes from the Knowledge sharing challenge.

Author: @Yosi_Neuman

Toggle auto-refreshing on and off faster

Try ctrl+shift+f9 within Dynatrace dashboards which will enable you to toggle auto-refreshing on and off.

If “writing” about refresh, the rate of refresh is dependent on the timeframe shown, as documentation explains:

12 Likes

Thanks for this information @Karolina_Linda, I have seen questions pertaining to this several times, thanks for posting this!

Does this work for Mac users as well? Is there a separate command? 
Tried “cmd + shift + F9” but does not work

Good news :slightly_smiling_face: Thank you!

on Mac: CTRL+SHIFT+FN+F9 (an alert will appear that autorefresh was disabled/enabled)