Hi!
We experienced over 10 seconds response time of a certain service on Feb 8th but Dynatrace did not detect it.
We could not find red zone on this graph.
There is no problem on this service detail page.

I confirmed the following 2 points but I am not sure why Response time degradation problem did not occur as we expected.
-
I referred this document and found the description “Applications and services have to run for at least 20% of a week before slowdown and error rate alerts are raised”
https://www.dynatrace.com/support/help/monitor/pro…
However, I calculated the run ration and the result is over 20 %.
-
I referred Settings > Anomaly detection > Services and found an option “To avoid over-alerting do not alert for low load services with less than 10 requests/min.”
However, I calculate the average value of requests to this service during 7 days before Feb 8th, then the result is over 10 requests/min.
Please see the result of calculation theresultofcalculation.xlsx
Do you think what I confirmed is beside the point?
Could you please let me know the other point I should confirm in order to enable Dynatrace to detect response degradation of this service?
Best Regards,
Natsumi Tanaka
theresultofcalculation.xlsx (27.1 KB)

