Upgrade cluster node from micro to other size

Dear All,

For cluster nodes, Is there any procedure to upgrade from Micro size to Small, Medium …

Or we just need to increase the needed component as RAM, CPU…

If you have the right way, thanks to guide me.

Thanks and have a good day.

Hello @Malaik

It seems, resources are not the only thing to change the cluster size but there are other factors/or combinations as well.

Managed hardware requirements

Regards,

Babar

Hi @Babar_Qayyum

Yes I saw the table,

But if I change the DiskSpace, RAM, CPUs, IOPS…

The size move by itself to upper size?

Hi @Malaik ,

the sizing itself is just a recommendation. The main parameter is RAM. For a typical environment, it is also recommended to increase CPU. Disk parameters are mainly about the ability to store expected amount of data from agents.

Julius

@Malaik For the node type to be indicated as another one above in the table, it has to have the CPU & RAM indicated. The Dynatrace Cluster also has to be restarted.

The important thing you should be after is that the Cluster doesn’t enter ALR. As @Julius_Loman has mentioned, RAM is normally the main parameter, followed by CPU. But, recently, it has been acknowledged the importance of disk: https://community.dynatrace.com/t5/Best-practices/Dynatrace-Managed-More-disk-IOPS-needed-for-the-robust/m-p/177117

Thanks @AntonioSousa

Do you know the way to check the actual IOPs for each node?

Thanks and have a good day.

@MalaikI personally use iostat, but please note it will give you only the IOPs in real-time, not the maximum value. If you want to benchmark, you will have to get a benchmarking tool.

Thanks for your feedback
Yes also use iostat, I just asked you to verify which one you are using.

Have a good day.