Dynatrace operator auto update

[Mizső]

Hi Folks,

As far as I remember dynatrace operator auto update did not work perviously. We always upgraded manually the operator time to time.  Today we observed that 0.10.02 upgraded to 0.10.03. It a good news we can forget the manual update. 

Did I missed something or the auto update worked before? But since when? 

I have not found any useful infromation in the documnetation and on the dynatrace operator git hub.

Bring me into the light.

Thanks in advance.

Best regards,

Mizső

[Romanenkov_Al3x]

Bye Bye manual updates 😃

Awesome. I will go to test it by myself.

[Julius_Loman]

Looks like the update is done by the platform (OpenShift in your screenshot?) and not by the operator itself - so it's pretty dependent on how you deploy the operator, isn't it? 

[shahinm · Accepted solution]

Hello,

There was an improvement within the OLM Marketplace listing (not visible in the Dynatrace Operator's GitHub repo), which caused the operator trigger an auto-upgrade. Please note that the change is only valid for the operator installed via the OCP operator hub.

[gouthamt]

Hi Shahinm,

Is a way to disable this trigger for auto-upgrade.

Thanks

[Mizső]

Hi @shahinm,

In this case it was installed via the OCP operator hub. Thanks for the information.  

Best regards,

Mizső