Typo in the downloaded dynakube.yaml

[Mizső]

Hi Folks,

I spent some hours to investigate a dynakube installation error at a client. I was a little bit blind.

During the installation we downloaded the dynakube.yaml from the GUI. The client had a decision that they will use the classicFullStack type.

We made a mistake during the configuration. Unfortunately, we replaced the type from the comments section with a copy.

The type parameter is case sensitive. So calssicFullstack did not work. We had to use classicFullStack. 😉

I hope you will not spend hours with similar investigation in the future.

Best regards,

János