21 Jun 2020
10:24 AM
- last edited on
25 May 2021
11:47 AM
by
MaciejNeumann
Hello,
I have created multiple naming rules in the API but it seems I can not enable them:
This is on global and on the service level, in the JSON "enabled":true is defined.
Am I missing anything?
KR Henk
Solved! Go to Solution.
Hello,
Found it, is is already activated. But you can not switch is off. But please be careful with this. The services where a match is made:
Response time degradation
The current response time (544 ms) exceeds the auto-detected baseline (6.59 ms) by 8,150 %
Response time degradation
The current response time (393 ms) exceeds the auto-detected baseline (11 ms) by 3,470 %
I hope this is only the case when switching in on, but could not wait for this )-;
After removing the rules in the API everything is ok again (-;
Please notice current response xxx ms baseline X.XX and the increase X,XXX, so the first is rounded, the second value has a dot and the percentage has a comma?
KR Henk
Hello,
Talked to Dynatrace, the switches can not be used by design,
KR Henk
Thanks Henk, yeah I was going to say that appears to be already on. It might take a few mins for the rules to apply.
Thanks for the feedback as well and the tips and tricks you discovered while working with the API!