cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

WAS 404 errors will not be displayed

MariaElena
Contributor

Hi Team,

 

Your help in knowing why 404 errors are not displayed in WAS (WebSphere Application Server) in Dynatrace:

 

MariaElena_0-1659451998766.png

 

Does anyone know why these 404 errors are not shown?

 

Regards

5 REPLIES 5

pahofmann
DynaMight Guru
DynaMight Guru

Have you checked the services of the WAS directly, if you see the 404s there? It should show them, even though they don't count towards the failure rate on server site.

 

Maybe the selected Management Zone or Timeframe is not correct?

Dynatrace Certified Master - Dynatrace Partner - 360Performance.net

MariaElena
Contributor

Hi,

 

At the log level I can't see them. But if you put a proxy on a computer, there are if you can see the errors.

MariaElena_0-1659539620961.png

But not in Dynatrace.

The filters of the management zones and the schedules if they are correct.

MariaElena_1-1659539826965.png

if I filter it by request count if it gives information.

MariaElena_2-1659539898118.png

 

Regards

If just check the service were the request should land directly if they show up at all. 

 

Maybe something before the first agent responds with the 4xx?

Dynatrace Certified Master - Dynatrace Partner - 360Performance.net

MariaElena
Contributor

Hi DynaMight, 

 

Validate and if we are consulting well in the management zone

We just don't see 404 errors, we do see 500 errors.

MariaElena_0-1661798454949.png

Do you know how the dynatrace agent does these searches for errors?

 

Regards

ljavelac
Frequent Guest

Hi Maria

 

It seems that Dynatrace doesn't consider 404 errors as failures by default.

 

ljavelac_0-1661805438829.png

But you can edit the service settings to consider 404 HTTP response as failures.

 

I provide you some steps to do this

 

1. Locate the service in dynatrace 

2. Edit failure detection settings

 

ljavelac_1-1661805807199.png

 

ljavelac_2-1661805921460.png

ljavelac_3-1661805982542.png

Also if you would like to this but globally for the tenant, you can configurate it in the tenant settings

 

settings >> server-side monitoring >> failure detection

 

 

ljavelac_5-1661806400964.png

 

Tell us if this works

 

Regards

 

 

 

 

 

 

 

 

 

 

Featured Posts