Showing results for 
Show  only  | Search instead for 
Did you mean: 

Does Enablement of RUM (at application level) requires service-restart?

If let's say I disable the RUM injection in process level, when I enable them later I think most likely I need a process-restart right?


How about the following scenario?
1. I never disable the RUM in process level.

2. But when detecting the application detection rule in the first place, I disable the RUM radio-button/switch. 

3. Later on I enable the RUM of the configured application by toggle the radio-button/switch.


So after step 3, do I need a service-restart of the underlying process?


Best Regards,

Wai Keat


DynaMight Legend
DynaMight Legend

No, you don't. If the processes run in full-stack mode, RUM injection start as soon as you enable the switch.

Certified Dynatrace Master | Alanata a.s., Slovakia, Dynatrace Master Partner

Thanks Julius.

Featured Posts